Utility-scale solar and wind provided the majority (53%) of new US generating capacity added in the first two-thirds of 2023, according to new FERC data.
In its newly released monthly “Energy Infrastructure Update” report (with data through August 31, 2023), the Federal Energy Regulatory Commission (FERC) says solar provided 8,980 megawatts (MW) of new domestic generating capacity, or 40.5% of the total. Solar capacity additions during the first two-thirds of this year were more than one-third (35.9%) larger than for the same period last year.
Other renewable energy sources also saw growth to the end of August. Wind provided an additional 2,761 MW (12.5%). With the inclusion of hydropower (224 MW), geothermal (44 MW), and biomass (30 MW), the mix of renewable energy sources accounted for the majority – 54.3% – of new capacity additions.
The new solar capacity additions edged past those of natural gas (8,949 MW). Capacity was also provided by the new Vogtle-3 nuclear reactor (1,100 MW) in Georgia as well as by oil (32 MW) and waste heat (31 MW).
Thirty-six “units” of new solar came online in August alone. Utility-scale solar’s share of total available installed generating capacity in the US rose to 7.2% – and keep in mind that FERC doesn’t even report data for rooftop solar. So utility-scale solar still trails wind (11.6%) but is closing in on hydropower (8%). So to date, renewable sources now make up 28.3% of total US installed capacity.
Going forward, FERC reports that “high probability” additions of solar between September 2023 and August 2026 total 83,878 MW – an amount nearly four times the forecast net “high probability” additions for wind (21,453 MW) and over 20 times more than those projected for natural gas (4,037 MW).
And that’s a conservative estimate – FERC reports that there may actually be as much as 214,160 MW of new solar in the three-year pipeline.
In three years, natural gas would still comprise the largest share of installed generating capacity (41.7%) but the mix of all renewables (solar, wind, hydropower, geothermal, and biomass) would total 34.2% and be on track to further reduce natural gas’ lead.
The SUN DAY Campaign’s executive director Ken Bossong, who reviewed the FERC data, observed:
Without interruption, each month solar energy increases its share of the US’s electrical generating capacity.
Now, 50 years after the onset of the 1973 Arab oil embargo, solar has grown from virtually nothing to a major part of the US’s energy mix.
To limit power outages and make your home more resilient, consider going solar with a battery storage system. In order to find a trusted, reliable solar installer near you that offers competitive pricing, check out EnergySage, a free service that makes it easy for you to go solar. They have hundreds of pre-vetted solar installers competing for your business, ensuring you get high quality solutions and save 20-30% compared to going it alone. Plus, it’s free to use and you won’t get sales calls until you select an installer and you share your phone number with them.
Your personalized solar quotes are easy to compare online and you’ll get access to unbiased Energy Advisers to help you every step of the way. Get started here. – ad*
FTC: We use income earning auto affiliate links.More.
The all-electric Cadillac LYRIQ was an Electrek favorite when it first made its debut two years ago. Now, LYRIQ buyers who have been waiting for a deal can score more than $10,500 in discounts on the Ultium-based Caddy.
Our own Seth Weintraub said that GM had come in, “a year early and dollar long at $60K” when he first drove the Ultium-based Cadillac LYRIQ back in 2022. He called the SUV “a stunner,” too, heaping praise on the LYRIQ’s styling inside and out before adding that the EV’s ride quality really impressed on long journeys.
Well, if the first mainstream electric Cadillac was a winner at its original, $57,195 starting price (rounded up to $60K for easy math), what could we call it at $10,500 less?
That’s a question that’s suddenly worth asking, thanks to huge GM discounts on the LYRIQ that prompted the automotive pricing analysts at CarsDirect to name the 2024 LYRIQ one of the industry’s “Best New Car Deals” this month:
A slew of incentives can enable you to save big on a 2024 Cadillac LYRIQ. First, EVs eligible for the federal tax credit qualify for $7,500 in Ultium Promise Bonus Cash from GM. Additionally, competing EV owners can score $3,000 in conquest cash.
With more than 100 kWh of battery capacity and 300-plus miles of real-world driving range (plus available 190 kW charging capability) the Cadillac LYRIQ ticks all the boxes – but you don’t have to take just my word for that.
A global shortage of qualified operators is impacting job sites everywhere, precisely at a time when demand for housing, mineral mining, and renewable energy construction is going from peak to peak. That’s why companies from Caterpillar to Tesla to Einride are pushing to advance autonomy the way they are.
First revealed as a concept in 2021, Volvo CE’s CX01 autonomous “single drum” asphalt roller concept has seen continuous development in the years since. Making its Volvo Days debut, the CX01 has shed the original single drum design for a “split drum,” with each half being controlled by an internalized, independent electric motor.
The CX01’s electric motors not only help to propel and steer the roller, they also vibrate the drums individually, using some trick software calibration to effectively “cancel each other out,” delivering all the benefits of vibrating drum rollers without the noise.
It’s so smart, you guys
It’s also worth noting that the CX01 is something of an “extended range” EV, instead of a “pure” BEV. That’s because it uses a small, 1.4L diesel engine to spin a generator that powers not batteries, but capacitors (those blue things, above right). Those capacitors can be charged on grid power (or from an accompanying TC13 trench compactor), but they’re much better than batteries at releasing energy really quickly, enabling the diesel to operate at its maximum efficiency while maintaining extremely precise, high-torque movement from the motors.
Volvo CE engineers envision a team CX01 rollers units deployed on larger job sites that could work together and communicate with other pieces of equipment on the site. The connected equipment could help survey the job site, report on the conditions of the mat (density, temperature, and passes), and leverage AI to determine when and where to compact without the need for human operators.
All of which is great, sure – but they had me at “giant OneWheel.”
Volvo TA15 autonomous electric haul truck
Volvo TA15 autonomous haul truck; photo by the author.
Part of Volvo CE’ “TARA” line of autonomous products, the “production ready” TA15 autonomous electric haul trucks are already part of a number of pilot programs on Volvo customer job sites. Being autonomous, they’re ideally suited to performing repetitive routes, dozens of times per day, without exposing human operators to fatigue or injury.
“TARA enables you to downsize and replace larger diesel-powered vehicles with a fleet of autonomous electric Volvo TA15s capable of running 24/7,” reads the official TARA release. “This not only helps you cut emissions and increase productivity, it will also help you rightsize your machinery and optimize your hauling routes.”
And that brings us to the real topic at hand: sustainability.
Electrek’s Take
Volvo SD110 single drum roller, via Volvo CE.
As we’ve often discussed on The Heavy Equipment Podcast, there are two types of sustainability, and both are important. The first is the “classic” version of sustainability, in that our choices need to sustain the planet and environment we live in. The second is sustainability of the business – the ability to keep doing business in a way that ensures the survival of the business, itself.
Looking at the conventional Volvo SD110 conventional roller, above, you can see the incredible amount of materials – of steel, rubber, plastic, glass, etc. – that simply isn’t needed to produce the CX01 roller we started this article with.
All that added mass has a massive hidden carbon cost. The cost of getting those materials out of the ground, the need for bigger, heavier roads to support the weight of the machine, and the bigger, burlier trucks and trailers needed to transport it. Heck, even the operator’s commute to and from the job site adds to the carbon cost of the SD110, over and above the harmful emissions from its diesel engine’s exhaust stack.
The CX01? It’s objectively more sustainable than the SD110 roller in every way, and does pretty much the same job.
Following successful inbound implementations in the Pacific Northwest, North Carolina, and Mexico, Daimler Trucks North America (DTNA) is expanding the reach of its electric semi fleet into Arizona with long-time associate JB Hunt.
JB Hunt will add the new Freightliner eCascadia electric semi to its Arizona fleet immediately, and put it to work delivering aftermarket truck parts from DTNA’s parts distribution center (PDC) in Phoenix to multiple DTNA dealers along a dedicated route.
The electric Freightliner truck is expected to cover approximately 100 miles in a given day before heading “home” to a Detroit eFill charger installed at Daimler’s Phoenix facility.
“This solution with DTNA is a great example of our commitment to supporting customers’ efforts to reduce their carbon footprint and work towards energy transition,” explains Greer Woodruff, executive vice president of safety, sustainability and maintenance at JB Hunt. “JB Hunt owns and operates several eCascadias on behalf of customers, and our drivers have really enjoyed their in-cab experience. As customer interest continues to grow, we are here to enable their pursuit for a more sustainable supply chain in the most economic means possible.”
Daimler is analyzing future expansion opportunities throughout its internal parts distribution and logistics with an eye on electrifing additional routes and further reducing the carbon footprint of its logistics operations.